Universal WLAN-ax/Bluetooth combo kit with M.2 plug-in card
The Shuttle accessory WLN-M1 is a comprehensive wireless LAN kit consisting of an Intel AX200 M.2-2230 plug-in card, two antennas and the matching antenna cables. This allows certain Shuttle XPC Barebones to be equipped with a wireless LAN function in accordance with IEEE 802.11n/ac/ax in the 2.4 and 5 GHz bands. This combo solution also supports Bluetooth 5.2.

Advantages of WLN-M1 compared to a typical WLAN USB stick:
1) The M.2 card is installed in the PC and is therefore better protected against tampering and theft.
2) The integrated solution looks more stylish.
3) For good efficiency, the antenna should be at least 6 cm long (= corresponds to half a wavelength at 2.4 GHz). The typical USB stick has a disadvantage here.
4) This WLAN card is a combo card that supports both WLAN and Bluetooth at the same time.
5) The PCI Express interface protocol is less complex than USB and typically generates less processor load.

Specification:
Package contents:
– M.2-2230 (NGFF) WLAN card: Intel Wireless-6 AX200NGWG.NV
– 2 antenna cables for XPC slim, length: 21 and 29 cm
– 2 antenna cables for XPC cube: length: 53 cm
– 2 dipole antennas
– Quick start guide (German, English, French)
Note: Device drivers are not included in the scope of delivery
Windows drivers can be found here: go.shuttle.eu/drivers

Compatiblewith the following Shuttle products:
– Shuttle XPC nano Barebone PCs: NC02Ux, NC03Ux, NC10Ux, NC40Ux
– Shuttle XPC slim Barebone PCs (1.3L): DH110(SE), DH270, DH310(S), DH310V2, DH370, DH410(S), DH470, DH610(S), DH670, DX30, DL10J, DL20N(6), DL30N(3), DH02Ux, DH32Ux, DS20Ux(V2), DS50Ux
– Shuttle XPC slim Barebone PCs (3-5L): XH110(V), XH110G, XH270, XH310(V), XH310R(V), XH410G, XH510G(2), XH610(V), XH610G(2), XC60J
– Shuttle XPC cube Barebone PCs: SH110R4, SZ170R8V2, SZ270R8, SZ270R9, SH310R4(V2), SH370R6(V2)(Plus), SH370R8, SH510R4, SH570R6 (Plus), SH570R8, SW580R8, SH610R4
– Shuttle XPC All-in-One Barebone PCs: P20U, P22U, P25U, P51U(3), P52U(3), X50V7xx, X50V8xx, X50V9xx
– Shuttle Edge: EN01J3, EN01J4, EN01E, EN01B (in combination with Shuttle Accessory LN007)

Supported operating systems
– Windows 10, Windows 11, Linux (64 bit)
– Windows driver download: go.shuttle.eu/drivers

Adapter card:
– Model: Intel Wireless-6 AX200NGWG.NV (non vPro)
– M.2-2230, A-E-Key (NGFF) plug-in card
– Host interface: PCI-Express for WLAN, USB for Bluetooth
– Dimensions: 30 x 22 x 2.4 mm (LWH)
– Temperature range: 0-80°C (operation)

WLAN standard
– Wi-Fi certification: WiFi 6 (802.11ax)
– Supports WiFi IEEE 802.11b/g/n/ac/ax in the 2.4 / 5 GHz band, 2T2R (2×2)
Security standards:WPA2 Personal and Enterprise, WPA3, 64-bit and 128-bit WEP, TKIP, 128-bit AES-CCMP, 256-bit AES-GCMP
Authentication protocols:802.1X EAP-TLS, EAP-TTLS/MSCHAPv2, PEAPv0 -MSCHAPv2 (EAP-SIM, EAP-AKA, EAP-AKA’)

Maximum PHY data rate:
– Supports Wifi 6 (WLAN 802.11ax) 2×2 with 1024QAM and 160 MHz bandwidth
– Maximum data transfer rate: 2400 Mbit/s

Bluetooth standard
– SupportsBluetooth5.2 in the 2.4 GHz band

Antenna cable:
– Four WLAN connection cables with different lengths: 21, 29, 53, 53 cm
– Connectors:
1) RP-SMA pigtail male
2) MHF IV (I-PEX4), HSC MXHP32 (Murata) compatible

Antennas:
– two external dipole antennas
– Frequency range: 2.4 / 5 GHz band, omni-directional
– Total length: 108 mm, diameter: 7.8-10.0 mm