DBP4019N+ - DACBerry PRO+ Audio Soundcard

DACBerry PRO+ Audio Soundcard

The DACBerry PRO+ is a high-end professional audio soundcard with a beautiful gold plated and matte black finish. It plugs directly on the Raspberry Pi A+/B+/2/3/3B+/4B. It is compatible with Asus Tinker board, Jetson Nano and others using the same GPIO.

It uses the Texas Instruments PCM5242 as main DAC, featuring balanced output, better signal-to-noise ratio and THD. With the Linux drivers built in to Raspbian, no kernel recompilation is needed, it’s supported by all the most used audio software.

It includes PurePathâ„¢ Smart Amp technology, which allows speakers to be driven with more peak power than their average-power rating, without damaging the speaker by voice coil over excursion or thermal overload.

DACBerry PRO+ also includes a 3 W Hi-Fi headphone amplifier delivering an amazing audio experience for those who listen through headphones. It’s compatible with studio headphones from 4 to 600 Ohm.

It also features the onboard I2C 4-pin connector for peripherals like the 1.3″ OLED display with an I2C cable. You can also add a MIDI extension board to get MIDI input/output.

• TI Burr Brown 32-bit/384 kHz DAC PCM5242 (Master Mode)
• PurePathâ„¢ Smart Amp technology
• Integrated hardware volume and mute control
• Built in 3 W Hi-Fi headphone amplifier (TPA6120A2)
• Class leading audio; 114 db SNR, and -94 db THD
• 6.35 mm audio jack for 4 to 600 Ohm studio headphones
• Built-in mini DSP
• Dual ultra low-jitter and low-phase noise oscillators
• Quad ultra low-noise LDO’s for analog and digital power rails
• Directly powered from the Raspberry Pi/Tinker Board/Jetson Nano
• Built-in header for external volume control
• Dual HW mute control for RCA and/or headphones
• SDBâ„¢ 1.2 connector
• Onboard I2C connector (Qwiic compatible) for peripherals
• Low-noise design with isolated digital and analog parts
• Compatible with all Raspberry Pi’s with the 40-pin connector
• Compatible with Asus Tinker Board and othes (Odroid, Banana Pi, XMOS interfaces..) using I2S protocol via SDBâ„¢ port
• Compatible with OSMC/RuneAudio/Volumio/Moode/PiCorePlayer/PiMusicBox/OpenELEC and others