OPNsense Ready System – APU2E4, 4 GB RAM, 16 GB mSATA SSD module, silver

The OPNsense software is based on FreeBSD(R) and was designed for use as a firewall and router. It includes almost all the features of expensive commercial firewalls, and in most cases even more. For example, the following functions are provided (excerpt):

• Firewall
• Status table
• NAT
• Redundancy
• Outgoing and incoming load balancing
• VPN – IPsec, OpenVPN, PPTP
• PPPoE server
• RRD Graphs Reporting
• Real-time information – with AJAX
• Dynamic DNS
• Captive portal
• DHCP Server and Relay
• Live CD version available

The OPNsense software runs on a power-saving APU2E4 system and has a maximum power consumption of 10 watts, which has a minimal impact on the environment. The system is fanless, passively cooled and extremely small (6 x 6″).

• APU2E update: The size of the battery socket has been changed to avoid contact problems. Added signal integrity resistor for core voltage control signal

Scope of delivery:

• 1x server system
• 1x 16 GB mSATA SSD module with pre-installed OPNsense software
• 1x 12 V power supply unit
• 1x network cable (1 m)
• 1x housing

• CPU: AMD Embedded G Series GX-412TC, 1 GHz Quad Jaguar Core with 64 bit and AES-NI support, 32K data + 32K instruction cache per core, shared 2 MB L2 cache
• DRAM: 4 GB DDR3-1333 DRAM
• Storage: boot from mSATA-SSD, SD card (internal sdhci controller) or external via USB, 1x SATA + power connector
• 12 V DC, around 6 to 12 W depending on CPU load, built-in socket = 2.5 mm, positive inner conductor
• Connectivity: 3 Gigabit Ethernet channels (Intel i210NIC)
• I/O: serial DB9 interface, 2x USB 3.0 external + 2x USB 2.0 internal, 3x LEDs on the front, push-buttons
• Extension: 2x miniPCI-express (1x with SIM connector), LPC bus, GPIO header, I2C bus, COM2 (3.3 V RXD/TXD)
• Board size: 6 x 6″ (152.4 x 152.4 mm) – like apu1d, alix2d13 and wrap1e
• Firmware: Coreboot
• Cooling: Conductive cooling from CPU to case with 3 mm thick aluminium heatspreader (included)